Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 04-15-2002, 12:04 PM
Budman Budman is offline
LawnSite Member
 
Join Date: Mar 2002
Location: kentucky
Posts: 65
Belt guides on Bunton 36"

I just replaced the engine-to-deck belt on a 36" Bunton Hydro. The manual says that there should be 1/8" clearance between the belt guide and the belt when the belt is in the engaged position. However, I noticed when it is running that the belt appears to make contact with the guide when it flops back and forth while it is turning on the pulley. The pulley and the shaft are not bent. Do I need more tension on the belt, or do I just need to increase the clearance on the guide. The contact between the belt and the guide appears to be slight and intermittent, but I am concerned that it will wear the belt over time.

Thanks for your replies!
Reply With Quote
  #2  
Old 04-15-2002, 02:29 PM
Richard Martin's Avatar
Richard Martin Richard Martin is online now
LawnSite Fanatic
 
Join Date: Mar 2000
Location: Greenville, NC
Posts: 14,499
It would probably wear out the guide before it wears out the belt. If it bothers you just back the guide off a little until it doesn't touch the belt anymore. If the belt starts jumping off of the pulley then you know you have the guide too far away. In-so-far as the belt tension goes you don't want too much tension, you could prematurely wear out the pulleys.
__________________
Serving Greenville, Winterville and Ayden NC



Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 07:53 PM.

Page generated in 0.06242 seconds with 7 queries