Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 04-23-2012, 02:54 PM
GreenscapeJosh GreenscapeJosh is offline
LawnSite Member
 
Join Date: Apr 2012
Location: KY
Posts: 5
Engine Dies

I have a 48'' toro hydro walk behind. Proline deck, Kohler command SP15 engine. The mower itself is an 08 and I dont think any major components have been replaced.
Mower model # 30528
Engine Model # CV15T
Now to my problem. . .
The mower will start revving a little once it goes then it will die. It will start back up first pull and idle fine but as soon as I engage the pto it will die again. Seems to be worse uphill. It has gotten worse over the past week that now I can't get two feet. I have changed the gas cap, fuel filter, fuel line. I've drained the tank and used new fuel. I took the bowl off the carb and made sure there was no water in it. Dropped the tank and cleaned it out. I've even took the carb off and cleaned it out real good. Now when I cleaned the carb/tank out it acted much better but slowly started to act up again. (it was doing this at the beginning of the season) I dont consider myself a mechanic even though I work on these a lot. I think I could fix it if I could just figure out what's wrong with it. Anyone have any ideas?
Reply With Quote
  #2  
Old 04-23-2012, 04:06 PM
GreenscapeJosh GreenscapeJosh is offline
LawnSite Member
 
Join Date: Apr 2012
Location: KY
Posts: 5
Forgot one thing, I can usually stop it from dying if i choke it. Even when I was cutting before it got as bad as it is now I could choke it to keep it from dying. Now it's so bad I can't mow at all but when I engage the blades if I choke it (play around with the throttle a bit) I can keep it from dying. Now sure if this helps but hey.
Reply With Quote
  #3  
Old 04-23-2012, 04:10 PM
cgaengineer's Avatar
cgaengineer cgaengineer is offline
LawnSite Fanatic
 
Join Date: May 2007
Location: Winder, GA
Posts: 15,777
Sounds like the high speed jet is plugged.
Posted via Mobile Device
Reply With Quote
  #4  
Old 04-23-2012, 07:20 PM
BigFish's Avatar
BigFish BigFish is offline
LawnSite Bronze Member
 
Join Date: Jul 2008
Location: chesapeake, va
Posts: 1,630
Sounds like a fuel starvation issue, so, first thing ya wanna do is enter your info here :http://www.kohlerengines.com/manuals/landing.htm and check out the carb section. Could be the fuel shut-off solenoid acting up, if yer too cheap to buy a new one, just cut the tip off the plunger. It will work fine, just let it idle/cool down for a bit before shutting it off. If not that, then you need to get into the carb again and clean it out. Pay attention to the float level/ inlet needle. Could be sticking.
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!"

......AMF!
Reply With Quote
  #5  
Old 04-25-2012, 03:09 PM
GreenscapeJosh GreenscapeJosh is offline
LawnSite Member
 
Join Date: Apr 2012
Location: KY
Posts: 5
Ya, cleaned the carb. again and it's running fine. Being that I just cleaned it out a little over two weeks ago why would it be dirty again? New filter/lines and I drained/cleaned the tank. What exactly is the fuel shut-off solenoid? That little rod behind the float?
Reply With Quote
Reply

Tags
dies , engine , fuel issue , repair

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 04:40 PM.

Page generated in 0.07284 seconds with 7 queries