Register free!
Search
 
     

Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 05-01-2012, 03:12 PM
ashs inc ashs inc is offline
LawnSite Senior Member
 
Join Date: Jul 2004
Location: alabama
Posts: 535
hypro pump

any help with changing the diaphram in a hypro d30 pump?

thanks
Reply With Quote
  #2  
Old 05-01-2012, 03:39 PM
RigglePLC's Avatar
RigglePLC RigglePLC is online now
LawnSite Fanatic
 
Join Date: Jul 2006
Location: Grand Rapids MI
Posts: 9,329
My suggestion: buy a special socket for your socket wrench. Get a special metric Allen wrench socket, (I think it is a 6 millimeter you need). You may need a regular 6 mm Allen wrench also, as the clearance may be too tight for some of the bolts. Unscrew the Allen bolts. Unscrew the big bolt in the center of the diaphragm (13 mm I think). Install new diaphragm using the bolt--there is a front and a back--the bolt will not go through from the wrong side. I think the label on the diaphragm goes to the inside. Rotate the pump using the starter cord, (being careful to not start motor), to help seat the diaphragm into the groove. Hammer on it gently with a wooden mallet if needed. Reinstall the pump head. Same on other side. Try placing a pan underneath to catch the oil as it runs out. Replace with new oil (30 w). Be sure to close the tank valves first. Wear gloves due to pesticides.

10 minute job--takes me about an hour. This is a good time to check for damaged valves or broken springs. Tighten the bolts in a criss cross pattern.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 02:23 PM.

Page generated in 0.06061 seconds with 7 queries