Register free!

The Green Industry's Resource Center


 
 
Thread Tools   Display Modes
  #1  
Old 04-03-2013, 09:36 PM
ReubenJames ReubenJames is offline
LawnSite Member
 
Join Date: May 2010
Location: Central Indiana
Posts: 3
Hustler wheel bearing replacement

I have a FastTrack SD and had a tire that keep going down so I took it off the get a tube for it. When I did one the wheel bearing fell out with little ball bearing all of the place. Before mowing season starts I going to replace all four (two on each wheel) and have got the part number. Are these bearing pressed in or do need any special tools or knowledge to remove the old ones and put in new ones.
  #2  
Old 04-03-2013, 09:54 PM
hustlermidwest hustlermidwest is offline
LawnSite Senior Member
 
Join Date: Sep 2012
Location: Chicago, Ill
Posts: 634
No special tool or press needed. Just take the biggest hammer you can find and place it where you wont use it. I would use wood or something soft when tapping in the bearings with a light hammer. Don't try to get them in with one shot, take your time and be smooth and all should be well. Don't forget your grease.

Brian O
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Layout Style:





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 12:18 AM.

Page generated in 0.06033 seconds with 7 queries