Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
05-04-2005, 10:55 AM
|
||||
|
||||
|
SCAG drive belt
The belt that goes around the shaft on the motor broke on my 48 inch beltdrive mower
it is the belt that connects to the transmission and i was wondering do u have to take the clutch off to replace the belt? 
|
|
#2
05-04-2005, 11:01 AM
|
||||
|
||||
|
No.
You do have to remove the engine to deck belt though to get the trans belt off. When you install the new trans belt, don't OVERTENSION it! Loose is better than tight. You'll destroy your transmission if you tighten it too much.
__________________
TLS 2004 GMC 2500HD Reg Cab BOSS 9.2 V-Plow 2013 eXmark LazerZ X-Series 60" 34hp EFI (RED) Kohler 2006 Hustler SuperZ 28EFI 60" Power Chute Design OCDC SOLD! Perma-green Magnum 1996 48" SCAG Belt WB 14hp Kawasaki Classic Deck Echo 2 strokes PB-755 Commercial Lawnboy trim mower Solo since 1980
|
|
#3
05-04-2005, 01:34 PM
|
|||
|
|||
|
I replaced mine 2 or 3 weeks ago on the 2001 36" Scag Belt Drive, I just loosened the screw on the tentioner and put it on with No Problem, after you take the blade belt off.
|
|
#4
05-04-2005, 01:40 PM
|
||||
|
||||
|
How did you get the belt around the clutch w/o removing the belt? You have to loosen the deck drive belt and slip it off the clutch.
__________________
TLS 2004 GMC 2500HD Reg Cab BOSS 9.2 V-Plow 2013 eXmark LazerZ X-Series 60" 34hp EFI (RED) Kohler 2006 Hustler SuperZ 28EFI 60" Power Chute Design OCDC SOLD! Perma-green Magnum 1996 48" SCAG Belt WB 14hp Kawasaki Classic Deck Echo 2 strokes PB-755 Commercial Lawnboy trim mower Solo since 1980
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
