Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
10-09-2007, 08:22 PM
|
|||
|
|||
|
23 hp kawaski govenor problem
I have a Exmark lazer hp with 23 hp kawaski. It was running fine until I tried to replace the oil seal around the govenoers shaft. I can not get the govenor to work properly know. Can someone help
|
|
#2
10-09-2007, 08:31 PM
|
||||
|
||||
|
Make sure your adjusting the governor properly;
__________________
Quote:
 "Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
#3
10-09-2007, 08:44 PM
|
|||
|
|||
|
I tried this and it didn't work. it revied very high. I'm thinking I have the spring that attaches to the govenor lever on wrong or something.
|
|
#4
10-09-2007, 09:06 PM
|
|||
|
|||
|
The model number for this motor is fh680va. I thought this might help. when i try the procedure that you sent , it runs wide open. Please help I need to cut tomorrow.
|
|
#5
10-09-2007, 09:29 PM
|
||||
|
||||
|
OK, I posted the wrong picture but the adjustment procedure is the same on your engine.
If the governor is adjusted properly, THIS is what you need to adjust; 
__________________
Quote:
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
