The Green Industry's Resource Center

johnnywalker · #1 01-05-2002, 12:18 AM

Anyone used this? any good? anything better?
Thanks

http://www.jackssmallengines.com/oil-pump.cfm

HBFOXJr · #2 01-05-2002, 08:16 AM

I have a hand pump vacuum one I boought at a marine supply store to do my boat and it is OK. I think I read in a review article that these were not too good. There are 12 volt available from Marine supply places as well.

keifer · #3 01-15-2002, 09:33 PM

I seen one at a dealer for 17 bucks that runs off a drill the owner of the shop said all of his macanics use them so as soon as i get back down there i'm going to get one. would have to beat tipping my vac over to change the oil.

LAZERMAN · #4 01-15-2002, 11:43 PM

BRIGGS AND STRATTON MAKES A PUMP LIKE KIEFER MENTIONED IT RUNS OFF A DRILL, IT BASICALLY WORKS LIKE A WATER PUMP THEY WORK REAL GOOD. OTHER COMPANYS MAKE DIFFERENT VERSIONS, BUT FOR A FEW BUCK TRY THE B&S AND IF YOU DON'T LIKE IT THEN YOU'RE NOT OUT MUCH MONEY. GOOD LUCK AND ENJOY.

johnnywalker · #5 01-16-2002, 02:23 AM

Isn't the Briggs one off the drill the one in the link above?

vipermanz · #6 01-16-2002, 03:15 AM

walmart has the pump itself for $8

keifer · #7 01-18-2002, 06:50 AM

I just seen one in the harbor tool cat for 7 dollars it looks like a bike pump with two tubes pull up and it draws the oil push down and the oil comes out. wish i had got it before the briggs.