|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#21
01-06-2002, 02:32 AM
|
||||
|
||||
|
update
i just got finished rebuilding it now, there was the dirty stuff in the fuel bowl, cleaned it up to perfection and will try again tommorow
__________________
<img src="http://img.photobucket.com/albums/v404/vipermanz/Newbanner.jpg" alt="Image hosted by Photobucket.com"> Check Out Weldingweb !!! 
|
|
#22
01-06-2002, 10:38 PM
|
||||
|
||||
|
Did you put a carb kit in it? That's what I need to put in my rider and my grandfather's edger. Post back with your results! Hope it worked well.
__________________
My truck: 1970 Chevrolet C20 My equipment: 1984 22" Yazoo BigWheel 5hp B&S I/C 1993 38" Craftsman rider 12.5hp B&S I/C 2004 Craftsman 17" gas weed-wacker 2004 Craftsman gas blower 1982 Trim-All edger 2hp B&S 1990's Stihl 009L, 14" bar 1964 McCulloch 250, 20" bar
|
|
#23
01-06-2002, 11:34 PM
|
||||
|
||||
|
Success!!!!!!!!!!!!!!!
i didn't use a kit,(wrong term)?,but i think it was just clogged up in the first place,
Thanks for all you guys help, You led me to another successful end!
__________________
<img src="http://img.photobucket.com/albums/v404/vipermanz/Newbanner.jpg" alt="Image hosted by Photobucket.com"> Check Out Weldingweb !!!
|
|
#24
01-07-2002, 12:10 AM
|
||||
|
||||
|
A carb kit contains gaskets, springs, screws, etc. Just curious about it. Glad you got it fixed!!
__________________
My truck: 1970 Chevrolet C20 My equipment: 1984 22" Yazoo BigWheel 5hp B&S I/C 1993 38" Craftsman rider 12.5hp B&S I/C 2004 Craftsman 17" gas weed-wacker 2004 Craftsman gas blower 1982 Trim-All edger 2hp B&S 1990's Stihl 009L, 14" bar 1964 McCulloch 250, 20" bar
|
|
#25
01-27-2002, 01:03 PM
|
|||
|
|||
|
THROTTLE SHAFT SLACK
CAN YOU MOVE THE THROTTLE SHAFT BACK AND FOURTH IN THE CARB HOUSING ? IF THERE IS SLACK IN IT YOU WILL NEVER GET IT TO ADJUST RIGHT CAUSE AIR IS PULLED IN AT THIS POINT ,WHICH IS DOWNSTEAM OF WHERE FUEL AIR IS MIXED
|
|
#26
01-27-2002, 11:31 PM
|
||||
|
||||
|
it's fixed now , it was a gunked up carb, but thank you for the help
__________________
<img src="http://img.photobucket.com/albums/v404/vipermanz/Newbanner.jpg" alt="Image hosted by Photobucket.com"> Check Out Weldingweb !!!
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
