Register free!
Search
 
     

Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 04-03-2009, 11:06 AM
irrig8r irrig8r is offline
LawnSite Platinum Member
 
Join Date: Dec 2004
Location: Silicon Valley, CA
Posts: 4,545
cool tools

Found over in the irrigation forum... tools for helping to pinpoint drill exit hole locations through walls (planning before you drill) while locating obstacles like pipe and wires.


http://www.zircon.com/products/metal_mt6.html

http://www.zircon.com/products/center_ms_i700.html

http://www.thru-wall.co.uk/ind1.htm


Post anything similar you know about.
__________________
Landscaper. Irrigator. Illuminator. Music lover. Coffee drinker.
Reply With Quote
  #2  
Old 04-08-2009, 07:18 AM
cgaengineer's Avatar
cgaengineer cgaengineer is offline
LawnSite Fanatic
 
Join Date: May 2007
Location: Winder, GA
Posts: 15,777
I know from experience a 2" drywall screw will find the incoming 220v line from a meter and will trip the outside breaker about as fast as you can say chit! The screw was going in and stopped, I pushed harder and it still would not go, I gave it one last nudge and all the lights of the building I was working on went off.

We all have had that idiot moment where we did something and right when you do it you realize that it was a mistake and you cant take it back. Lucky for me on this project I caused no permanent damage to the wire or the circuit.

This was not a low voltage lighting job.
__________________
Georgia Applicator License Number 09102

"A well-regulated militia being necessary to the security of a free state, the right of the people to keep and bear arms shall not be infringed."
Reply With Quote
  #3  
Old 04-09-2009, 09:13 AM
Pro-Scapes's Avatar
Pro-Scapes Pro-Scapes is offline
LawnSite Platinum Member
 
Join Date: Apr 2005
Location: South Mississippi
Posts: 4,224
I think we need to rememeber drilling saftey and basics first here. While there will be accidents alot of them can be avoided with a good visual inspection.

When drilling on utility walls such as near panels and power meeters use extreme caution

No substitute for a good visual inspection. Look for signs of electrical, gas, plumbing, hvac, central vac etc. If in doubt inspect further or consult with a qualified party.

When drilling thru exterior walls your holes should be slanted slightly so the outside of the hole is a tad lower than the inside..

Wires going thru walls should be in conduit and per code always.

Always seal your holes to prevent moisture damage to the structure.

Always ensure you have a proper drip loop outside or other suitable means for water run off so that it does not ride the conduit or cable inside.

All these fancy toys are great but there is no substitute for common sence.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump






Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 04:26 PM.

Page generated in 0.07062 seconds with 9 queries