|
#31
|
||||
|
||||
|
Nice trailer! Can't wait to see the finished pics!
__________________
Joe J&R Lawn and Landscaping 23 years old, Fully licensed and insured. 50+ accounts 2011 8x16 Pace Summit trailer 2010 Exmark TTHP 17/48 04 Exmark Viking 32" 96 Exmark Metro 36" Echo, Redmax, and Shindaiwa handhelds. Husky chain saws. 2010 F-350 4x4 6.4 PSD w/ 8' Western plow. 1997 F-250 4x4 7.3 PSD 2004 Bobcat 61" 25hp ZTR for sale. 1100 hours, Under 10 hours on a TOTAL DECK REBUILD! PM for details |
|
#32
|
|||
|
|||
|
Here are some updated pictures ofthe work I have been doing to my enclosed trailer. Throughout the week I will add some more. I painted the floor and ramp with Bedliner paint from Walmart. I put down 3 coats which was about 1.5 gallons. I also framed out the shelves and hopefully will being finishing the shelf floors tomorrow.
|
|
#33
|
|||
|
|||
|
Looks dang good there xclusive! Good choice going with the roll on bedliner and your color combo looks very similiar to mine
Paint the workbench the same color to finish it off (if ya werent already).
|
|
#34
|
|||
|
|||
|
Thank you!! Yea I def plan to paint the work bench.
|
|
#35
|
|||
|
|||
|
Where do you live? Wayne. Im from wayne too.
|
|
#36
|
||||
|
||||
|
Looking good, I like the idea of the lining on the floor but I think the black and footprints and stuff would drive me nuts. Here's how mine turned out all gray.
|
|
#37
|
|||
|
|||
|
Yea Im from wayne over by route 23. What part are you from?
That looks good!!! What shelving system did you use? I know what you mean with the footprints but either way the floor is gonna have marks on it so it doesnt bother me. |
|
#38
|
||||
|
||||
|
I used all green touch stuff. the trimmer racks are the 4 place extreme series, the 3 bp blower racks are the normal racks and the U hooks for the tools are from lowe's and were a sh*t ton cheaper than what I believe the green touch ones run.
|
|
#39
|
|||
|
|||
|
Im from over off of preakness ave. I just bought a new enclosed trailer today from wayne fertilizer,2010 Homesteader Challenger 8.5x16 and i was looking to see other peoples new setups on here and came across yours. Looks good so far . I dropped it off to get lettered already this afternoon but theyll be done with it by tomorrow night. Ill be startin to set it up wed. You planning on lettering it?
|
|
#40
|
|||
|
|||
|
Quote:
|
![]() |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
|
|





Paint the workbench the same color to finish it off (if ya werent already).







Linear Mode
