|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
06-22-2010, 08:03 PM
|
|||
|
|||
|
John Deere RX75 speed problems
I just finished a major overhaul of the kids RX75. After putting everything back together the thing moves very slowly forward. About the same speed as reverse. Anyone have any tips for adjusting this?
Thanks |
|
#2
06-22-2010, 08:55 PM
|
||||
|
||||
|
Quote:
So what all did you have apart ?
__________________
Quote:
 "Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
#3
06-22-2010, 09:18 PM
|
|||
|
|||
|
EVERYTHING!
 I had to replace the sheave on top of the transmission, so after getting that far...... I tore down just about everything else. Cleaned her up. Soaked the carb for about a week in a simple green solution. (the kids had been running it without a filter) Replaced belts, got the rear tire that was stuck on, un stuck. I'm wondering if the new belt is too big? Came from the Deere dealer and looked right, but it seems that the belt doesn't get tensioned until the shift arm is 3/4 way forward. Hmmmm. I wish I had the maintenance manual. |
|
#4
06-22-2010, 09:51 PM
|
||||
|
||||
|
Quote:
Hmmm, Do you mean a service manual by chance ? Something like this ?  http://www.keepandshare.com/doc/view...d=2001177&da=y It may take a few minutes to download..... Things to keep in mind, When dealing with a vari-drive system it's best to replace belts in pairs. Installing a new belt with a used/stretched belt can cause ground speed issues, Also....After installing a new belt start the unit and with the gear selector in neutral operate the speed control pedal a couple times. Doing this will center/neutralize the belts in the vari-drive pulley.
__________________
Quote:
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
#5
06-23-2010, 02:43 PM
|
||||
|
||||
|
Look in your manual there is a thing under the seat you have to adjust. i just replaced the belts on mine and had the same problem
__________________
Exmark Lazer Z John Deere RX75, 14SE Little Wonder SHO Blower Echo PB2100, Echo PAS 230, Power Pruner Stihl-SH86,HS45 24",Miniboss,026 Pro, FS100RX Husqvarna 150bt 1959 Farmall Cub 
|
|
#6
06-24-2010, 04:29 PM
|
|||
|
|||
|
Problem solved! Thanks guys. A new primary belt and an adjustment to the variator did the trick. Thanks for all the help! Now I'm turning the kids loose on the grass.
|
|
#7
06-23-2011, 01:45 PM
|
|||
|
|||
|
Restrorob, could you please repost the link to this manual?
Currant link does not work or I am doing something wrong, Thanx http://www.keepandshare.com/doc/view...d=2001177&da=y |
|
#8
06-23-2011, 06:06 PM
|
||||
|
||||
|
Hello Joe, I share too !
 Try it again as you requested, Let me know when you get it saved to your PC. The link is only good for X amount of time.....
__________________
Quote:
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
#9
06-23-2011, 07:07 PM
|
|||
|
|||
|
Thanx
Finally got down loaded, Thanx again
|
|
#10
06-23-2011, 07:37 PM
|
||||
|
||||
|
Your welcome Joe....
__________________
Quote:
"Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
 |
| Bookmarks |
| Tags |
| john deere, rx 75, rx75, transmission |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
