wrench size to change my blades out on my exmark E series?

[olebrooklawn]

read the owner booklet didnt see what kind or size tools I need to change out blades. help if you can.

[EastCoast]

My SCAG is 15/16, not sure about Exmark. You dont have a few wrench that you could try?

[olebrooklawn]

Originally Posted by EastCoast

My SCAG is 15/16, not sure about Exmark. You dont have a few wrench that you could try?

wanna find out before i raise her up. I know for a fact its not a bolt. its a screw.

[jsslawncare]

Pull the cover off the deck, There maybe a 15\16 nut there. I have never owned one of these mowers but the rest seem to be this size.

[Mark Oomkes]

Originally Posted by olebrooklawn

wanna find out before i raise her up.

Why does that matter? It has to be raised up either way, right?

And if it's a "screw" as you say, a wrench won't fit it. You need a screwdriver.

Can't you just reach through the discharge and try some different size wrenches on it from there?

Wouldn't that have been faster than starting a thread on it?

[JDiepstra]

Originally Posted by Mark Oomkes

Why does that matter? It has to be raised up either way, right?

And if it's a "screw" as you say, a wrench won't fit it. You need a screwdriver.

Can't you just reach through the discharge and try some different size wrenches on it from there?

Wouldn't that have been faster than starting a thread on it?

Hey you can make useful posts!

[EastCoast]

Then just take the deck cover off like mentioned below and apply various wrenches on the nut.

I use a 15/16 socket on my impact wrench over the nut and a 15/16 open end wrench over the head of the bolt. Very simple.

[davidcalhoun]

You can find the hex nut size in the parts manual. You can then figure out what wrench size.

[Patriot Services]

I have never seen a mower blade held on by a screw?!?
Posted via Mobile Device

[StanWilhite]

It may take a metric adjustable wrench.