Register free!

The Green Industry's Resource Center





 
 
Thread Tools   Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 10-09-2011, 09:56 PM
Shawn S Shawn S is offline
LawnSite Member
 
Join Date: Mar 2008
Location: Brookings, SD
Posts: 87
Accelerator install problem

I bought a bagger for my JD 647A which has the 48" deck. This is a 2011 mower.
The bracket that came with the bagger and the bracket in the pictures of the installation instructions are slightly different.
The bracket in the install photos is 1" wider at the rear of the bracket than the bracket that came with the bagger. The install photo bracket has a 1" kickout at the rear that my bracket does not have. The instructions tell me to space the front of the bracket 2 3/4" from the front lip and 3 3/4" from the back lip. Since I am missing 1" at the rear it is not possible for me to space it 3 3/4". My thought is to simply run the bracket 2 3/4" at the front and rear but wanted to post here to see if that is OK.
Below are some photos. The first two photos are my bracket. The third photo is a picture of the install page. You can see the tape starts around 1" in both photos and ends around 3 3/4" on the pictured bracket but only 2 3/4" on my bracket.

PS - this bagger is great. Of course I haven't used it yet, but the construction of it is amazing. I can't wait to get it installed so I can start playing with it.
Attached Images
     
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Forum Jump




Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 10:40 PM.

Page generated in 0.08504 seconds with 9 queries