Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #21  
Old 09-25-2012, 08:41 PM
piston slapper's Avatar
piston slapper piston slapper is offline
LawnSite Platinum Member
 
Join Date: Mar 2010
Location: Tampa Fl
Posts: 4,002
Crater...The emmision police gave Kohler a huge headache a few years ago when the told them that the adhesive they used was not compliant ...
They had to use a lesser glue on their magnets...
Use JB Quik Weld...sets up in about 5 minutes in 80 degree temps..
Use 1 inch strips of thick cardboard and bend them in half...in a vee..
Insert them between the magnets while gluing...watch your spacing..
I usually mark the previous locations on the flat area on the flywheel..
Make sure the magnets and flywheel are CLEAN...
You can keep slightly repositioning the magnets until the JB Quik starts to set up...
CAUTION...if the flywheel magnets migrate to each other..the flywheel will be out of balance...and COULD take out the machined bushing in the top
of the block...which is not replaceable...
Just keep an eye on it till it dries....you'll be ok...
Posted via Mobile Device
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 11:15 PM.

Page generated in 0.12860 seconds with 8 queries