who else makes idley pulleys?

[grass disaster]

this is exactly what i need 5" X .5

its actually a 5" x .635 with a .5 sleeve.

i could make the sleeve for any diameter bearing as long as its bigger than .5

so i need a pulley 5" by .5+


just seeing what else is out there.

http://qualityfarmsupply.com/product...ey-5-dot-00-od

[pugs]

V pulley? Flat pulley? Flat with lips? 5" from flat to flat? 5" to lips? How wide or what series V belt? and the list goes on.

Oregon or Stens sell lots of pulleys. Most that use reducer bushings have a .669 ID bearing.

[grass disaster]

Its a V....standard belt. 5/8 belt I think!
Posted via Mobile Device

[JimQ]

Try an Oregon 34-106 Pulley

With either a 78-100 (flush) or 78-102 (1/4" offset) bushing

or you could try and JB Weld a slightly used (but still good) bearing back in the old pulley.

Q