Accelerator Aluminum Grass/Leaf Catcher. Will need some welding

[davidcalhoun]

Hi, I need to thin the garage of some projects from several years ago. Back then, I got a Lesco 48" Commercialplus mower that came with this catcher on it. The catcher has just been sitting in my workshop and it's time to sell it to someone who can use it.

This catcher will need some aluminum straightened and the welds redone and it should be just fine. See pics.

$140 buys it. Local pickup is preferred at Granger, IN 46530. Yes, I will ship it if buyer pays for boxing and shipping cost.

[TinMan1]

any idea if it will fit a 36"

[davidcalhoun]

No, I do not know. You might call Accelerator and ask them. If it does not, It may just take a different bracket than the one that came off of the Lesco mower.


Note: The bracket that was on the Lesco comes with this catcher.

[travisn1]

Which size capacity is this? The 4.15 cu ft?

[davidcalhoun]

Yes, I believe it is the standard size.

[travisn1]

Is there a way i can contact you to get more details? I was unable to send a private message or e-mail. It may be because i just registered a new username...I have some interest in discussing further.

[davidcalhoun]

Since you can not PM yet, the best way would be to post your number here and I call you.

[PeterA]

This is a 4.15 catcher for a Lesco mower. It would fit Scag advantage decks fairly well, as long as one was not mowing at a low height (it will ride about a 1/2 inch lower than the catcher we make for the scag advantage deck).

It would not work at all for an exmark or toro mower.

[davidcalhoun]

Thanks Peter.

I am sure your reply will answer several questions.

[davidcalhoun]

Bump for the weekend