Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 10-18-2012, 07:53 PM
Schrock Lawns's Avatar
Schrock Lawns Schrock Lawns is offline
LawnSite Senior Member
 
Join Date: Nov 2010
Location: virginia beach va
Posts: 947
Grandstand oil darking

I bought a grandstand last month with 267 hours changed the oil go to check the level today 277 hours and it was relly relly dark and relly low also the dipstick is changing colors is that a problem also sometimes when I start it it blows a big puff of white smoke has the 24 hp kawi fs691v anything wrong or is this normal?
Posted via Mobile Device
Reply With Quote
  #2  
Old 10-19-2012, 12:33 AM
herler herler is offline
LawnSite Gold Member
 
Join Date: Apr 2012
Posts: 3,432
There are three things that will cause sudden darkening of the oil on air-cooled engines, sludge build-up and a blown cylinder head gasket, both are relatively easy fixes, I find it odd that you'd have a sludge build-up problem with that low hours unless the oil had not been changed at all...

And if the oil has not been changed in a long time it is not unusual for oil to darken quickly after it is finally changed, if this were the case a second oil and filter change would be a likely fix, some folks like to simply stick to the recommended change interval and not let it go as long.

Well there's always rings but I doubt your engine would pull much if that were the case.

To address the sludge problem (which again is unlikely if you changed the oil regular) I like to get the engine up to operating temperature, shut it down, then take 1/2 pint of kerosene and dump it in the crankcase, now...
Start the engine and run it on idle for 6 minutes do NOT run the RPM's above idle !
After 6 minutes shut the engine off and change the oil and filter immediately.

That usually gets rid of sludge if it were an issue, in severe cases a second treatment may be required but more than likely if it still darkens quickly you probably need to replace the cylinder head gasket(s).

Now the head gasket(s), that's a procedure I'm not getting into here.
But a good better than half a chance that's your problem to begin with, because of the low hours.

Last edited by herler; 10-19-2012 at 12:40 AM.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 02:33 PM.

Page generated in 0.06682 seconds with 9 queries