Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#91
12-14-2012, 08:23 PM
|
||||
|
||||
|
Question #9...Kohler Magnum 20 hp
Condition...Engine smoking and leaking oil...oil level OK..14 psi crankcase pressure.. Name That Failure
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough... Do The Work 
|
|
#92
12-14-2012, 08:30 PM
|
||||
|
||||
|
Question #10...Kohler CV750 30 hp DSAI ignition
Condition...Engine running on 1 cylinder...remove and replace the sparkplug lead while the engine. Is running...the dead coil starts firing again...runs another hour and it stops firing..RnR the lead and its firing again... Name That Failure
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough... Do The Work
|
|
#93
12-14-2012, 08:36 PM
|
||||
|
||||
|
Question #11...Kohler CV740...DSAI ignition..
Condition...No spark while cranking...however if you cycle the key quickly back to the run position...it will start and run fine...replaced key switch...no change... Name That Failure
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough... Do The Work
|
|
#94
12-15-2012, 07:06 AM
|
||||
|
||||
|
Question #12....Kohler Command CV25
Condition...Not charging...new stator...flywheel..and regulator...12 volts to middle wire on regulator. Still not charging... Name That Failure..
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough... Do The Work
|
|
#95
12-15-2012, 07:20 AM
|
||||
|
||||
|
Question #13...Exmark Lazer Z with 27 hp Kohler
Condition....Little Billy got up early on the day after Thanksgiving to buy a new Lazer and get one free. He only needed one so he stored the other one in his shed for 3 years...in the 3rd year the Lazer he was using started having a few issues...so....he pulled his new 3yr old mower out of the shed and serviced the battery and the carb.....life was good.... At 10 hours the engine threw a rod...the welch plug fell out of the crank and the engine lost oil pressure.. Is this a warranty ???
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough... Do The Work
|
|
#96
12-15-2012, 09:23 AM
|
|||
|
|||
|
Quote:
Can't be a bad carb, I know where they are made...
|
|
#97
12-15-2012, 09:39 AM
|
||||
|
||||
|
Quote:
at 8 hours.
__________________
Masters Degree in Thinking Out Side Of The Box Graduate of the MacGyver Institute of Ingenuity The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic 
|
|
#98
12-15-2012, 09:39 AM
|
||||
|
||||
|
Quote:
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!" ......AMF!
|
|
#99
12-15-2012, 09:40 AM
|
||||
|
||||
|
Quote:
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!" ......AMF!
|
|
#100
12-15-2012, 09:42 AM
|
||||
|
||||
|
Quote:
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!" ......AMF!
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
