Unknown front diff

[Bungy]

How can I tell the difference between a GM 10 bolt front diff and a Dana 44? I have a 78 Chevy K-20. It has heavy duty everything. The rear diff is a GM 14 bolt with 10.5" ring gear. Also how difficult is it to change a np203 to part-time? Any input would be appreciated. Thanx, Bungy

[Alan]

Look on the casting where the housing attaches to the axle tubes, next to the cover. I can't remember which side of the housing it's on but Dana will ahve the model number cast in there somewhere. I think it's on the upper right side, facing the cover, in the web that reinforces teh housing at that point. It's clearly visible at any rate.

[mycave]

Chucks chevy trucks has a picture of a dana 44.

[fran]

Originally posted by Bungy
How can I tell the difference between a GM 10 bolt front diff and a Dana 44? I have a 78 Chevy K-20. It has heavy duty everything. The rear diff is a GM 14 bolt with 10.5" ring gear. Also how difficult is it to change a np203 to part-time? Any input would be appreciated. Thanx, Bungy

I BOUGHT A CONVERSION KIT FROM JC WHITNEY, MADE BY MILE MARKER, IT COST $115 I THINK IT ALSO COMES WITH NEW LOCKOUTS, VERY EASY TO INSTALL, YOU DON'T EVEN HAVE TO REMOVE THE CASE JUST THE TAILHOUSING.

[Chuck Smith]

Here's a picture of the Dama 44. Hope it helps. You can see the "44" cast into the diff housing on the drivers side in the pic.

<img src="http://www.chuckschevytruckpages.com/images/dana44a.jpg">

http://www.chuckschevytruckpages.com/images/dana44a.jpg


~Chuck