|
#1
|
|||
|
|||
|
Kawasaki FB460V Loud Whine at Startup
Kawasaki FB460V engine (very loud) whine at startup, after engine warms up , the whine goes away. More pronounced when unit is not run for awhile. Engine is on John Deere 165 Lawn Tractor. Could this be a bearing noise?? Fluids levels are good...
Thanks for the help.. |
|
#2
|
|||
|
|||
|
First I would seperate the clutch and drive belt from the engine to make sure the noise is not traveling up into the engine,and if it still did it i would say that it is proberlly a bearing ,the 460 v in some cases would tend to throw the balancer through the block but i cannot remember if it wined first,also you might use a piece of wood and place it as close to the bearings as possible to figure out where the noise is most pronounced
|
|
#3
|
|||
|
|||
|
Belt Dressing...
Dave,
Thanks for responding!! Since the first posting, I tried to locate the whine, it seemed to come from the lower half of the Mower. I then thought the belt could be slipping until it warmed up. I then purchased some Belt Dressing, applied some, and the Whine has gone away. Thanks again. Jerry...
|
![]() |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
|
|












Linear Mode
