The Green Industry's Resource Center

Old 05-06-2004, 11:05 PM
fixer67's Avatar
fixer67 fixer67 is offline
LawnSite Silver Member
Join Date: Apr 2004
Location: Tryon NC
Posts: 2,155
Walker PTO shaft tool

I got sick and tired of fighting for up to half and hour with PTO couplings so I came up with this tool. I made it out of 1/4 steel which turned out to be a mistake because I had to thin it down. 3/16 would be a better choice to use. I used an old coupling as a guide so there are no measurements, it is a cut and fit deal. You use the tool by simply pulling back the collar and inserting the tool in between the collar and clip. And with the collar locked back it is so much easier to slid the coupling on the shaft. I found it is easier to remove the tool by taking you trigger finger and pulling it stright down. If you look close you will see a "V" notch cut out in the tool this is for the ball to fit in.I hope these pictures load right.

<img src=" Tool/807.jpg">

<img src=" Tool/805.jpg">

<img src=" Tool/806.jpg">

<img src=" Tool/808.jpg">
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Layout Style:

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2016, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Grand View Media
All times are GMT -4. The time now is 04:10 AM.

Page generated in 0.05973 seconds with 10 queries