Problems with toro walk behinde

[joshua74133]

anyone know why the blades would just stop after 10min of use then blow a fuse???
it's a 32" walk behind toro mower
after it has shuts down, it wont re engage until after it has set for a few hours.

Every time it does this i change the fuse, wait an hour and after it's cooled ill start it up it will run great and cut good for about 10min but again out of the blue the blades just stop spinning while the mower is working fine.

[lawns Etc]

Bad clutch! Has short internal

[ricky86]

If you have a multitester, check the resistance between the two lead that go to the clutch (when it's unplugged). Should be 2-4 ohms.

[joshua74133]

does anyone know where i can find the clutch that goes on a 05 toro proline 32"