Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 03-16-2000, 09:17 AM
lawrence stone's Avatar
lawrence stone lawrence stone is offline
Banned
 
Join Date: Jan 2000
Location: anthracite valley, commonwealth of pennsylvania Winter residence: Charlotte County FLA
Posts: 2,079
A few weeks back I mounted my new used 62” mowing deck to<br>my best traction unit a 1995 with an 18hp V-twin Kohler.<br>I did the swap at a friends heated garage (he has everything<br>cutting torches, arc welder, even a milling machine).<p>At that time I noticed the deck belt was quite loose and the<br>idler had no more adjustment. When I would go and engage<br>the clutch (pto) the engine would stall out and die unless you<br>gave it about half choke. The house and garage sits on an acre<br>so there were some matted down leaves in this turf which the<br>62” with new mulching blades promptly destroyed.<p>So yesterday I got this 62” off my trailer to work on the<br>machine in the front of the trailer. I started the clutch on<br>half choke and found only the center spindle was turning.<br>Well it seems the deck belt was never in the pulley on the<br>center spindle. I just removed the idler setup from the deck<br>to position the deck belt around the v pulley. I then just reinstalled<br>the idler setup and was then able to adjust the belt to the<br>correct tension.<p>Now you can engage the pto with the choke in the full run position.<br>I have a bracket mounted on the 62” (my 52” machines also) to accept <br>the Wright Mfg. Jumbo metal bagger. This machine did a fine job bagging<br>even with the mulching blades. In a short time <br>all the clipping/leaves<br>were being piled up against the back of the bagger.<p>I have been able to retain the deflector shields for these units by raising the<br>shields up an inch by using a leftover piece of an end cut off a JRCO bar.<br>I just take and cut the square metal tubing the same size as the deflector<br>mounting brackets and drill on a press. Then put the bagger in place and<br>drill new holes in the deck where the deflector will fit the best. In my<br>case I paint the tubing red to give it that OEM look then install with<br>longer bolts.<p>The maiden voyage for my 62” is scheduled for 3/21 at the school district. <br>I will take a 52” with me “just in case”.<p><br>
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.com™ - Moose River Media
All times are GMT -4. The time now is 01:13 AM.

Page generated in 0.06019 seconds with 7 queries