Accelerator pin

[robertsturf]

We have 2 Accelerator baggers for our Wright Standers. The problem we have is the pin on the smaller bagger is too short and falls off continually and on the larger bagger the pin bends up just enough to allow the bagger to drag slightly and mess up the stripes. Is there anyway to improve this or repair either mounting system??

[robertsturf]

Anybody from accelerator moniter this board??

[PeterA]

Hi Robert,

We do monitor this board! I am on vacation this week so I am just getting around to it today. At any rate, your pin should stick out from the bottom tube by about 3/4 of an inch. This should not be a problem on any of the more recent catcher models as far as digging into the ground, unless your catcher is riding really low. We would be happy to send out a replacement pin for you at no charge to fix the problem with the short one. If you want to call me at the office next week I would be happy to try to help you out with your catchers in any way I can.

[robertsturf]

Thank you very much. I think that is the issue. It only sticks out less than 1/2". The larger bagger sticks out 1". These baggers are 2 & 3yrs old.