Register free!

The Green Industry's Resource Center



Reply
 
Thread Tools   Display Modes
  #1  
Old 08-25-2009, 08:54 PM
kaashlock kaashlock is offline
LawnSite Member
 
Join Date: Jul 2009
Location: etown Kentucky
Posts: 8
Insulated stud on side of 14 hp Briggs?????

I have a 14 hp twin briggs. There is a stud with a nut on the side of the engine (starter side) that is insulated from the engine. It will not ohm out to the block. Is this the kill stud for the engine. In other words, if I run a wire from it to a toggle switch to kill the engine will it work. If not how do I kill the engine. It is wired to a toggle and push button and I can't shot it off without choking it out.
Kenny
Reply With Quote
  #2  
Old 08-25-2009, 09:50 PM
kogafortwo's Avatar
kogafortwo kogafortwo is offline
LawnSite Member
 
Join Date: Jul 2008
Location: Charleston, SC
Posts: 85
If it is the shut off connection, there should be two wires to this stud:

1. The one you already have that goes to the kill switch

2. A wire from the coil to this stud

If the coil wire is missing, maybe it got cut off or it is buried under the recoil cover somewhere, but then it would tend to short accidentally and the engine wouldn't run.
__________________
tired of long equipment lists
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 01:52 PM.

Page generated in 0.06916 seconds with 7 queries