rings for walker kohler20

[dobe]

Is there a place I can order rings and head gaskets etc for a kohler 20hp motor in a walker mt?
Pretty sure my rings are worned out and i think I have a blown head gasket on one side.

thanks

[Restrorob]

Either one, Google is your friend.....


http://tewarehouse.com/

http://www.rcpw.com/

[dobe]

Originally Posted by Restrorob

Either one, Google is your friend.....


http://tewarehouse.com/

http://www.rcpw.com/

used google all night but cant seem to find the rings for the ch20 for walker
tewarehouse don't list them for that motor.

the rcpw.com looks like they might have it if I had the part number, and I dont.

[Restrorob]

Originally Posted by dobe

ch20 for walker

Forget about the above part, Post the Spec number off this engine.

[dobe]

Originally Posted by Restrorob

Forget about the above part, Post the Spec number off this engine.

must have too much dirt on the motor every sticker i found wont the right one.

where is it normally at on the ch20's? not in the same place as my cv

[Restrorob]

There should be a white decal on the flywheel cover near the top.....

[dobe]

Originally Posted by Restrorob

There should be a white decal on the flywheel cover near the top.....

im outside now cleaning it off, should know something soon.

[dobe]

Originally Posted by dobe

im outside now cleaning it off, should know something soon.

that sticker is not there anymore. its got 17XX hrs on it so who knows.

anything else i can look for?

[Restrorob]

Dinner bell just rang....Back shortly.....

[Restrorob]

OK,

If this engine has the drive pulley on the flywheel side with no shaft sticking out of the other side we can assume this isn't a "Basic" engine.

If that's the case there are only seven engines listed for Walker units, All ring part numbers on these engines supersede to new numbers as listed below;

Rings STD; 24 108 22-S
Rings .25 ; 24 108 24-S
Rings .50 ; 24 108 13-S

Complete engine overhaul gasket set; 24 755 107-S

Without a spec number you can only assume these rings will fit your engine, I'm pretty sure the gasket set will without problems.....


Good Luck