Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
05-25-2002, 09:19 AM
|
|||
|
|||
|
replacing clutch, how to?!?
I'm trying to replace the cluthc on my 36" scag but the axel is kind of in the way =( how do i get the dang clutch off?!? the center bolt is out, just the clutch hits the axel and won't come out....hope i don't have to pull the motor for this one...
__________________
Jeffrey R. Orkin 
|
|
#2
05-25-2002, 10:27 AM
|
|||
|
|||
|
i know someone knows how to replace an electric clutch on a w/b....come on!!! =( kinda stuck here....
__________________
Jeffrey R. Orkin
|
|
#3
05-25-2002, 10:46 AM
|
||||
|
||||
|
i went and looked at my 36" scag and it looks like it should just fall right out with a little shaking and wiggling, but i have not replaced mine yet. I will let you know if i figure out anything else.
Kevin Williams Lawn Mgmt
|
|
#5
05-25-2002, 11:52 AM
|
|||
|
|||
|
next question, the clutch i took off seems to hvae a built in woodrif key....the new clutch isn't the exact same design, and i'll have to go buy a woodrif key, diff brand clutches also....the design is close but not exactly the same, it was ordered from jthomas so do you think i should slap it on there and see what happens or what?
__________________
Jeffrey R. Orkin
|
|
#6
05-25-2002, 04:28 PM
|
|||
|
|||
|
the replacement clutch is like the new scag one. if you buy it from scag it comes with a new key. the clutch you are replacing failed because of the cheaper bearings.
jerald Last edited by Administrator; 10-04-2002 at 10:39 PM.
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
