Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
08-29-2002, 02:08 PM
|
|||
|
|||
|
Carb rebuild ?'s
On an echo engine, say a pb650, what is entailed in rebuilding a carb?? What exactly is replaced?? The diaphragm??
Whenever I suspect carb troubles, I take them apart, clean with cleaner and air, and reassemble. This has always taken care of the problem. 
|
|
#2
08-29-2002, 06:37 PM
|
||||
|
||||
|
Havent had to do my pb650 carb yet but on my 20" chainsaw
kit included diaphram, gaskets, spring, pin, etc-about 12 pcs. could have got the quick repair kit - 4 pcs. full kit about 1/2 hr going slow quick kit about five minutes-this usually fixes most problems-very simple job my saw is older (10yrs) so newer carbs may not even have 12 pcs to replace-
__________________
If you want people to notice your faults, start giving advice.
|
|
#4
08-29-2002, 07:35 PM
|
||||
|
||||
|
If its got a walbro carb you can order a kit from this site.
get the # stamped on the carb http://users.1st.net/mkw94/saws.htm scroll down & click on carb rebuild kits
__________________
If you want people to notice your faults, start giving advice.
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
