THEGOLDPRO'S 2011 Stripe/Equipment thread.

[THEGOLDPRO]

Originally Posted by kitts lawn care

Lookin good.

Thanks buddy.

[THEGOLDPRO]

Originally Posted by 944own

I just got a lazer also and I think I need to lower the stripe kit about how far would you say the bottom of the roller should be below deck.
Posted via Mobile Device

I adjusted the stripe kit yesterday when i got home, it was a a pain to adjust because its hard to get under the mower to reach it with the wheels on, so i ended up taking the back wheels off and adjusting it. There are only 3 positions the kit can be adjusted to, mine was in the middle, so i lowered it to the 3rd slot all the way down. Ill let you know if it makes a difference or not tomorrow when i start mowing again.

[grincon]

Stripes look good. That one's gotta be about a 1/4 mile long!

[THEGOLDPRO]

Originally Posted by grincon

Stripes look good. That one's gotta be about a 1/4 mile long!

Thanks man, It is a decient size yard. just over 3 acres of mowing.

[944own]

Originally Posted by THEGOLDPRO

I adjusted the stripe kit yesterday when i got home, it was a a pain to adjust because its hard to get under the mower to reach it with the wheels on, so i ended up taking the back wheels off and adjusting it. There are only 3 positions the kit can be adjusted to, mine was in the middle, so i lowered it to the 3rd slot all the way down. Ill let you know if it makes a difference or not tomorrow when i start mowing again.

Post results for sure
Posted via Mobile Device

[THEGOLDPRO]

Originally Posted by 944own

Post results for sure
Posted via Mobile Device

You bet ya.

[944own]

This may be a stupid question but on my old z the lesco the front castor wheels are on like a pivoting axle i guess you could call it. The new lazer castor wheels are in a fixed position and I find either the left or right castor wheel coming off the ground allot on the least bit of uneven terrain. Is this normal? thanks

[THEGOLDPRO]

Originally Posted by 944own

This may be a stupid question but on my old z the lesco the front castor wheels are on like a pivoting axle i guess you could call it. The new lazer castor wheels are in a fixed position and I find either the left or right castor wheel coming off the ground allot on the least bit of uneven terrain. Is this normal? thanks

Yea its normal.

[SkinnyVinny]

you think that those exmarks make all the stripes, but this is the goldpros REAL striping machine

[THEGOLDPRO]

Originally Posted by SkinnyVinny

you think that those exmarks make all the stripes, but this is the goldpros REAL striping machine

lol, what did that mass airflow come off of an mx-6?