Register free!

The Green Industry's Resource Center



Reply
 
Thread Tools   Display Modes
  #1  
Old 12-22-2002, 08:20 AM
nokomower nokomower is offline
LawnSite Member
 
Join Date: Jul 2002
Location: Nokomis, Fl
Posts: 6
What is the easiest way to unload a pickup truck

I have a 92 Dodge 150 p/u V6 with a bed liner. I am intrested in finding something to help unload yard waste. I have seen in some magazines a add on dump bed kit and I have also seen the cargo unloaders that roll out the load. I unload alot of palm fronds, I average about 1700lbs of yard waste. Has anyone found anything that works to make the trip to the dump any easier and faster. :
Reply With Quote
  #2  
Old 12-22-2002, 05:05 PM
robert payer's Avatar
robert payer robert payer is offline
LawnSite Senior Member
 
Join Date: Feb 2002
Location: Parma, Ohio
Posts: 282
Noko,

A slide in electric lift dumper would work well. The over the cab protector shield is nice to have. This could cost as much as $2500.00 installed if new. Used ones can be found for about $1200.00. A cheaper alternative is to stand a spare tire in the bed behind the cab. Have a chain attached to the center of the tire. The chain must be long enough to extend out of the bed and be locked around a tree or post. Then drive forward pulling most every thing out of the truck. You will need a rake to finish the clean out. Not a bad way to go.

You might also do a search. Many discussions on this topic have been seen here on Lawnsite.

Hows the weather there in Florida? Cold here in Cleveland!

Go Gators!
Reply With Quote
  #3  
Old 12-22-2002, 05:15 PM
ksland's Avatar
ksland ksland is offline
LawnSite Senior Member
 
Join Date: Mar 2001
Location: Cape Cod, Ma
Posts: 928
Loadhandler, goto www.loadhandler.com
Reply With Quote
  #4  
Old 12-22-2002, 06:17 PM
gogetter gogetter is offline
Banned
 
Join Date: Jan 2001
Location: Yardley, PA.
Posts: 3,256
I've seen the EZ Dump inserts advertised for as low as $1895 installed.

But I have a question, is the Dodge 150 you mentioned a half ton (an older model of a 1500 series?)?. If so, I don't think the EZ Dump is for you. I think it weighs like 700 lbs alone. Add 1700lbs of debris and you're gonna break your truck!

Considered a heavier duty truck? If you do go for a heavier duty truck, some of the dump options are:

EZ-Dump inserts
Maxi-Dump inserts
Little Tipster inserts
TruckCraft inserts
LoadHog (it's an airbag that raises your stock bed to dump)

and probably a couple others I've forgotten.
Reply With Quote
  #5  
Old 12-22-2002, 11:04 PM
PaulJ's Avatar
PaulJ PaulJ is offline
LawnSite Bronze Member
 
Join Date: Nov 2001
Location: Columbus, NE
Posts: 1,777
Get a big tarp (8X10) before you dump anything in the bed hook the edges of the tarp to the sides of the bed or tuck the back corners in the tailgate and the front corners in the toolboxlic (if you have one) When your ready to dump -- un hook the tarp, pull it back a little so the edge is at the back of the gate, climb in and grab the FRONT corners of the tarp and pull like he** The whole load just rolls right out.

Remember to layer more tarps in the load if you have a lot to haul. Ive been doing this for a few years now. It's fast, cheap, and easy

Sorry I don't have any pictures
Reply With Quote
  #6  
Old 12-23-2002, 11:51 AM
Brickman's Avatar
Brickman Brickman is offline
Guest
 
Join Date: Mar 2002
Location: eastern WY
Posts: 1,249
I always used a pitch fork.
Reply With Quote
  #7  
Old 12-27-2002, 10:32 PM
nelbuts's Avatar
nelbuts nelbuts is offline
LawnSite Bronze Member
 
Join Date: Apr 2002
Location: SW, FL
Posts: 1,055
Hey nokomower we aren't that far apart. In fact used to do alot of work in Venice area. Plantation, Jacarranda, Venice Island, etc. Here is the easiest way I found for a pick-up with out costing you much money.

1. Get a 10x12 tarp, put about 1/3 on the bed the rest on thop of cab for cover.

2. Get a 4 prong pitch fork heat each prong and then bend them over about 8 inches at a 90 degree angle.

When you get to dump you can pull a bunch out at a time. When you get to wear you see the bottom of the tarp on your bed then you should be able to pull the rest out. Takes me about five minutes or so, sometimes 10. But let me warn you coconuts are a *****! The pitchfork keeps getting stuck! So you have to watch them bad boys.
__________________
The biggest oak is just a stubborn nut that held it's ground.
Reply With Quote
  #8  
Old 12-27-2002, 10:38 PM
65hoss's Avatar
65hoss 65hoss is offline
LawnSite Fanatic
 
Join Date: Sep 2000
Location: Memphis, TN
Posts: 6,360
Re: What is the easiest way to unload a pickup truck

What is the easiest way to unload a pickup truck

44 mag :blob4: :blob4:
__________________
Reply With Quote
  #9  
Old 12-27-2002, 10:47 PM
Nebraska Nebraska is offline
LawnSite Senior Member
 
Join Date: Jan 2002
Location: Beautiful Great Plains.
Posts: 525
Paul,

How much weight have you been able to handle that way?
Reply With Quote
  #10  
Old 12-28-2002, 03:48 AM
PaulJ's Avatar
PaulJ PaulJ is offline
LawnSite Bronze Member
 
Join Date: Nov 2001
Location: Columbus, NE
Posts: 1,777
nebraska

I can't say in pounds about wieght, but this fall I had a pretty big load.
I Power raked and dethatched my parents lawn as part of renovating, because they lost a large area from drought.
I bagged the debris with my mower and it had a lot of dirt in it also.

With two or three tarps layered I had my pickup pilled high till it was spilling over the edges. and even had a tarp full on the trailer.

It all came off pretty slick but I had my brother helping me pull the tarps.

In heavy growing times I might fill the pickup bed level layering two tarps and be able to pull it off myself. The trick is to not let any one layer get too heavy to pull of yourself.

I might have some left to sweep or blow out but it sure beats scooping or raking the whole thing.

I might try to get a series of pics unloading this spring so I can explain it better.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 04:31 PM.

Page generated in 0.09636 seconds with 9 queries