Enclosed Trailer Skin Removal

[HB Lawn]

Ok, I have this 16 ft enclosed trailer that I need to remove the skin off the back ramp door, but I can't find the right Torx screw driver and bit to fit the screw heads. I tried a number T15, just a little too small and a T20 is way to big. So I think I need a T16, but i can't find one anywhere. Can someone point me in the right direction to find this special driver. Or if you have a trick up your sleeve, let me know.

Thanks
HB Lawn

[ParkWelding]

Its most likely not Torx. Look closely and its 8 points. Use a square bit and they will come right out.

[R & R Yard Designs]

#2 square bit.
Posted via Mobile Device

[HB Lawn]

I have a #2 bit that I'll try tomorrow.

Thanks
HB Lawn

[LuckyFlyinROUSH]

Car shops have alot of specialty tools. They usually sell them individually. Try Carquest, Autozone, etc.

[justanotherlawnguy]

Square bit it is!

I went through the same thing not to long ago. Never thought about a square bit until trailer repair guy told me about it. Bought a 2 pack at home depot and it worked like a champ!
Posted via Mobile Device

[blk90s13]

Yea its a square bit I needed to tighten a couple of screws on mine and that what worked for me as well

[HB Lawn]

Well what do you know, it is a #2 square bit.

Thanks for the help.

HB Lawn

[joes169]

Not sure how rusty or corroded the screw are, but if they're bad, hold the square bit with a 1/4" wrench and strike it abrubtly with a small hammer, and it should be loose enough to turn out with a drill w/o stripping. Usually, the ramp doors corrode relatively fast, especially in the "rust belt".......

[lawnpropm]

Had this same issue with trying to change a tail light on mine. Square bit it is lol best of luck!!!
Posted via Mobile Device