Originally Posted by djt22
Don't over think it if you are used to pushing and pulling just add the use of a spade to push the pipe back and forth between holes with one guy on one end and another at the glue end. Use the back side of the spade jabbing it in the ground at a slight angle to allow you to push it towards the hole with the glued fitting on it. *Always do the end head last of course. A lot easier than beating up your foot all day....
totally, but i think it may be too late, after several good rains on the installed pipe, before i can get back to the job, which was out of my control.
like i said, i will try but dont think it will work. i tried on one the other day while finishing up a job and it was a no go. pipe would not give an inch, this was installed the same time as the job i am worried about.