![]() |
|
|||||||
| Hustler Turf Equip Lawn Mowers & Turf Care Equipment |
![]() |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Super walk behind trouble with clutch?
Hi PJ,
yesterday while cutting a lawn my deck stop,so start looking for the problem i made sure the safety harness was still connected right cause sometimes it would disconnect itself. after looking at the wiring i noticed a wire of the neutral lock switch broke of so i redid the connection,now the deck doesn't want to start again, how could i know if the clutch is shot? because that's only thing that comes to mind right now engine runs fine,deck doesn't want to start
__________________
48" hustler Super walk behind 2005 KM 90 Stihl timmer 2010 22" Toro mower 2005 21" Toro Super bagger 2011 |
|
#2
|
|||
|
|||
|
My good friend PJ has moved on to better himself. Until a suitable replacement can be found I will try to fill in.
The loose wire concerns me mostly because the clutch demands all safety interlock to be working in order for it to work. Double checking your repair job making sure it is correct, the next thing I would check is a fuse. Because of the loose wire and deck failure happened at the same time I would not assume the clutch failed. Do you have power going to the clutch when the PTO switch is turned on? If not I would work backwards to find the open. If you do have power to the clutch, well your fears of a bad clutch might have come true. Brian O |
|
#3
|
|||
|
|||
|
thanks Brian
Sad news on PJ ![]() where is the fuse located? i have a recoil mower when the deck stop working it kind went on and off within 3 sec till it finally stopped i didn't even know there was a fuse on the
__________________
48" hustler Super walk behind 2005 KM 90 Stihl timmer 2010 22" Toro mower 2005 21" Toro Super bagger 2011 |
|
#4
|
|||
|
|||
|
Fixed the problem,belt safety connection wasn't on right
__________________
48" hustler Super walk behind 2005 KM 90 Stihl timmer 2010 22" Toro mower 2005 21" Toro Super bagger 2011 |
|
#5
|
|||
|
|||
|
Nice Job! Thanks for reaching out.
Brian O |
![]() |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
All times are GMT -4. The time now is 11:55 AM.
Forum Rules:
This hustlerturfequipment.com sponsored forum is administrator monitored. LawnSite.com does not allow any manufacturer competitor attacks and will strongly enforce this. If you want your discussion to be viewable by the public and responded to in a professional manner then please keep your discussions professional and to the point.
All discussions are viewed by the administration before being released to the public. Your post may not be made viewable for up to 48 hours. Please allow the manufacturer representative enough time to respond to your question or comment once made viewable.
LawnSite.com is not affiliated with the Excel Hustler company. This forum is provided by LawnSite.com to Excel Hustler in order to better server their customers