Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
10-09-2012, 09:42 PM
|
|||
|
|||
|
Dump insert mounting
idk if this is the right forum or night but here goes. I just bought a bri mar dump insert and i have never had one before. I need to know how do you bolt it in do you go through or do you use the bolt holes next to the crossmembers that are in the bed underneath??? also this is going in a 2002 chevy 2500hd again i dont have the bolts but do have the brackets and their slotted so im figuring square it up and get idea of where to drill????
Any advice would be much appreciated thanx!! 
|
|
#2
10-09-2012, 10:19 PM
|
||||
|
||||
|
My one Ford was easy, just pull the oem bed bolts but Chevy I think you just measure a couple inches back from the front of the bed and square it up and drill through the bed. I would use some type of plating underneath, maybe 1/2 thick steel plate. I know a guy who just used washer's and it started pulling though.
__________________
J and B Lawncare: On our own as of 2003. Proud to be a full time, legitimate company. Equipment we use: Ford trucks Pro Line and GatorMade trailer's Gravely, Exmark, Honda and Snapper mower's Echo trimmer's and blower's LittleWonder equipment BillyGoat equipment New Holland and Dresser loader's (snow removal) Fisher snow plow's DownEaster and Fisher salt spreader's TurboTurf fertilizer tank http://jandblawncare.net
|
|
#3
10-09-2012, 10:29 PM
|
|||
|
|||
|
I was thinking square 1/4" plating washers and yeah I picked it late today so will look better tomorrow cause I m looking at the manual and Its saying you have to go through the frame/crossmember
Posted via Mobile Device
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
