Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#2
10-12-2012, 04:47 PM
|
||||
|
||||
|
Quote:
|
|
#3
10-12-2012, 04:50 PM
|
||||
|
||||
|
I have used everything from a flatfile, angle grinder, flapper wheel and drill. I always come back to my 70 year bench grinder with an adjustable tool rest to keep the 30 degree angle right.
Next 5 posts will be from Magna owners that are convinced there is no other way than an expensive dedicated machine. Posted via Mobile Device
|
|
#5
10-12-2012, 05:12 PM
|
||||
|
||||
|
A little plastic cone. HD has them for less than ten bucks.
Posted via Mobile Device
|
|
#6
10-12-2012, 05:39 PM
|
||||
|
||||
|
On commercial units, I use an angle grinder, either air or electric. Usually I sharpen em in situ. On the smaller chit, I always use my air die grinder with a 3/4dia. carbide cylindrical burr. Absolutely will not burn the edge! If they are really bad I might use my angle grinder first, but always finish with the carbide cutter.
If I remove em to sharpen, I always balance em' with a magnetic unit, the same one that advertises on here.
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!" ......AMF!
|
|
#7
10-12-2012, 06:43 PM
|
||||
|
||||
|
Quote:
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!" ......AMF!
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
