Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#11
10-23-2012, 08:13 PM
|
||||
|
||||
|
Nice tools Fish...nothing like a custom made tool to get the job done...
Over the years I have invented more than a few tools ..out of necessity or frustration... Maybe when it slows a bit ....I will share a few of them with you guys... Posted via Mobile Device 
|
|
#12
10-26-2012, 08:10 AM
|
|||
|
|||
|
Got them out. The only way to do this was to mill them out. It was not easy, but I got it done. The Rod end removal was a challenge also. The eye bushing was worn so a replacement was needed. When I went to remove it it snapped off leaving a 1 inch stub of threaded shaft sticking out of the pusharm. I had to weld a nut on the snapped stub, heat the pusharm cherry red and even then it was real tough to get out. In the end I saved $150.00 but wouldn't want to do it again.
Last edited by flashbang; 10-26-2012 at 08:20 AM.
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
