Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
11-29-2012, 07:35 PM
|
|||
|
|||
|
Ferris home made striping kit
Made a striping roller since ferris only offers the rubber flap. That makes the grass spring back up stripes are not as deep in color.. Roller makes them lay down and you can not see the tire marks
|
|
#2
11-29-2012, 07:36 PM
|
|||
|
|||
|
Beautiful work!!!
|
|
#4
11-29-2012, 08:11 PM
|
|||
|
|||
|
Any pictures of the grass after using this?
|
|
#5
11-29-2012, 08:34 PM
|
|||
|
|||
|
No, sorry I dont. This is a new mower and it made it today. Ill have to wait until spring!
I made something like it before on my last mower and landscapers would stop when i was out cuting the lawn to ask what i was using. So i guess they looked good.
|
|
#7
11-29-2012, 10:34 PM
|
|||
|
|||
|
i know its been on here before, but where did you get your materials.
__________________
 Insured and Licensed
|
|
#9
11-29-2012, 11:17 PM
|
|||
|
|||
|
how much did all of it cost, minus the paint? I think i am going to do this with my lazer, does it get in the way of anything backing up? i think the only problem with this system is trailering it with another zero turn. Normally the wheels of my two lazers fit right outside the engine mount metal .
__________________
Insured and Licensed
|
|
#10
11-29-2012, 11:31 PM
|
|||
|
|||
|
It's fine backing up it pivots up so it follows the ground. You can't tell from the picture but it only sticks out further then the rear bumper about an inch. I'm going to put eye hooks on it so you can raise it upand hook it to the bumper when not in use and that would solve your trailer problem. The wheels were the most expensive a little over a hundred and I think I spent about 50 on the rest. The axle was 3/4" gas pipe.
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
