|
#1
|
||||
|
||||
|
12 volt pump question
If you had a Delavan Fatboy 7870 "demand" (not bypass) 12 volt pump which is rated at 7.0 gpm and 100 psi could you install a bypass pressure regulator? I realize this would cause the intermittent duty pump to run continuous, but aside from the overheating issue, could it be done? Hose from tank to pump inlet, then on the outlet side of the pump installing a Tee. One hose going to the reel, the other going back to the tank. On the bulkhead at the tank, a pressure regulator and gauge.
What are the issues aside from overheating the pump that is made for intermittent duty?
__________________
7 years in the business. Oklahoma Licensed Pesticide Applicator (3a) 2012 Hustler X-One 60" with 26hp Kaw 2011 12'x83" Landscape Utility Trailer Echo Handhelds 50 gallon Skid www.facebook.com/YardBossLawncare |
|
#2
|
||||
|
||||
|
I may not have clarified my question good enough. Other than the pump overheating, would there be any calibration issues by forcing a demand pump to run continuous by installing a pressure regulator? I think this particular pump is too big to use with a lawn gun and 1.5 gpm tip. I'm trying to keep the pump from cycling on and off too often. Any thoughts are appreciated.
__________________
7 years in the business. Oklahoma Licensed Pesticide Applicator (3a) 2012 Hustler X-One 60" with 26hp Kaw 2011 12'x83" Landscape Utility Trailer Echo Handhelds 50 gallon Skid www.facebook.com/YardBossLawncare |
|
#3
|
||||
|
||||
|
LHD
While I have never used Delavan pumps, I have successfully used Shurflo 12v pumps with a By pass regulator. I am not so sure the Shurflo demand pumps are intermittent duty. They seem to last pretty long in continuous uses. Calibration should be more consisted using a by pass regulator. .
__________________
. "As Americans you have the right to be stupid." John Kerry "Life is tough, but it's tougher when you're stupid.” John Wayne. |
|
#4
|
||||
|
||||
|
They use a 12 volt Delavan pump on z spray and they run continuous with a buy pass.
I don't think your pump will over heat you will be fine It will work fine with a buy pass and a pressure reg Charles Cue |
|
#5
|
||||
|
||||
|
Thanks for the replies, both of you. I think it will work too. I'll keep you posted.
__________________
7 years in the business. Oklahoma Licensed Pesticide Applicator (3a) 2012 Hustler X-One 60" with 26hp Kaw 2011 12'x83" Landscape Utility Trailer Echo Handhelds 50 gallon Skid www.facebook.com/YardBossLawncare |
|
#6
|
||||
|
||||
|
I run this same exact pump in both bypass mode with a regulator and intermittent duty. I have had it for 3 years and have not had a problem with it. It is great when you want to spray early in the morning and not wake up the neighborhood.
Posted via Mobile Device |
|
#7
|
||||
|
||||
|
Quote:
__________________
7 years in the business. Oklahoma Licensed Pesticide Applicator (3a) 2012 Hustler X-One 60" with 26hp Kaw 2011 12'x83" Landscape Utility Trailer Echo Handhelds 50 gallon Skid www.facebook.com/YardBossLawncare |
![]() |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
|
|












Linear Mode
