Click for Weather
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#1
03-02-2013, 05:42 PM
|
|||
|
|||
|
Kawasaki FH721 FH680 23 25 HP Engine How would you remove the bushing in block
Just was wondering how everyone else does it and what they use? Pics of any tools to remove or install? I do this every week and was just wondering the different ways. You know some say the glass is half full, and some say its half empty. The block has its own bushing that is not removable that is the same id and od with only 1/4 inch space between the two. So you have to knock it out from the inside, but its hard to get to without making your own tool to install and remove. I have made my own tools. Just looking to see others...
|
|
#3
03-03-2013, 01:37 PM
|
||||
|
||||
|
Nice pics. I use a modified cape point chisel. I started using a blind bushing puller, but found the chisel works better for me.
__________________
" But let me tell you something ,folks: You can't fix stupid! There's not a pill you can take, there's not a class you can go to. Stupid is forever!" ......AMF!
|
|
#4
03-04-2013, 08:06 AM
|
|||
|
|||
|
I started out using a chisel
But it would get into the block and gouge it. Then you have to grind it out so the new bushing would fit right. Or else the chrank wouldnt go back in the new bushing. I have seen that happen at a few of the dealers.
|
|
#6
03-04-2013, 10:02 AM
|
|||
|
|||
|
Uninstall tool
http://www.ebay.com/itm/Crozier-set-...c1fe3e&vxp=mtr is the tool you need to uninstall
|
|
#7
03-04-2013, 12:04 PM
|
||||
|
||||
|
Quote:
__________________
Quote:
 "Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
#8
03-04-2013, 02:31 PM
|
||||
|
||||
|
Quote:
Hey Rob I just don't have 200k of machines laying in my garage for engine building. They also balance crank pistons line bore etc. I get a friend price. I just put them together. For our equipment.
|
|
#9
03-04-2013, 07:34 PM
|
||||
|
||||
|
Quote:
If you paid sumbuddy to do it fer yoo...you didn't do the work..or get learned up on it.. Just cause I paid sumbuddy to build my house...doesn't make me a contractor... BTW...it dusnt take 200k to change a bushing...just a bushing driver kit...
__________________
If You Have All The Answers...Except The One You Need...You're Not Trying Hard Enough... Do The Work
|
|
#10
03-04-2013, 08:06 PM
|
||||
|
||||
|
Quote:
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
