Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 06-20-2013, 01:52 PM
cnymowing cnymowing is offline
LawnSite Member
 
Join Date: Mar 2007
Location: Cicero NY
Posts: 118
Kawasaki fh440v had water in the gas now won't run right

On my phone so ill be brief. Gravely belt drive walk behind with a Kawi fh430v-cs06:

Yesterday I get a call that the mower died, I check it out and find about 2 gal of water/separated fuel. I drained it and replaced fuel filter. Filled it back up and ran fine.

Today I get a call that it was sputtering and not running right. I cjeck it out and the fuel is fine, but it wasn't getting a spark on either cylinder. Also the oil was very foamy...

I disconnected the kill wire from each coil, got spark and got it running with the kill wires off. When I connect one kill wire at a time, it still runs... Bit rough. Connect both and it dies. Would this indicate a coil problem or a kill switch problem? If a kill switch problem (which I think it is) where and how should I start troubleshooting? If a coil problem, how do I troubleshoot?

I also just changed the oil and filter since I found the foam... Am I right to believe that the foam was caused by the water in the gas? Could todays problems be associated with the bad gas? Anything else that I should do because of the watered fuel?
Posted via Mobile Device
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 10:01 PM.

Page generated in 0.05388 seconds with 9 queries