Register free!

The Green Industry's Resource Center



Reply
 
Thread Tools   Display Modes
  #1  
Old 02-27-2004, 12:28 AM
ALLFERRIS ALLFERRIS is offline
LawnSite Member
 
Join Date: Feb 2004
Location: Illinois
Posts: 32
What size zero turn to buy?

I'm looking to buy my first zero turn and need some advice. Now I have two 48" WB and a 61" WB. What size Z should I get. Does a 52" sound right? I only use one 48 and the 61, the other is a back up
__________________
K
Illinois
Reply With Quote
  #2  
Old 02-27-2004, 01:06 AM
specialtylc specialtylc is offline
LawnSite Bronze Member
 
Join Date: Jan 2004
Location: Washington state, eastsider
Posts: 1,652
60inch is apretty good choice. Need pretty flat ground for a 72. And the 60 will get into about as tight as areas as a 52 or 54.
__________________
KUBOTA/HUSTLER User
Reply With Quote
  #3  
Old 02-27-2004, 01:50 AM
Tonyr's Avatar
Tonyr Tonyr is offline
LawnSite Bronze Member
 
Join Date: Sep 2003
Location: Melbourne,Australia
Posts: 1,976
Hi Kevin,

a 60'' deck is most used for by general contractors, not too big and not too small, a good design will have a good amount of left side trim overhang

I just bought, actually today, a new toro 588e, efi and 60'' turbo force deck, this machine can go into tighter areas than my toro front mount pictured left. Seriously!

28hp kohler, efi, 60'' deck, mulch or side discharge, does both great, certainly enough power!

Yeah, so demo a toro 588E, you will like it.
__________________
Reply With Quote
  #4  
Old 02-27-2004, 01:57 AM
ALLFERRIS ALLFERRIS is offline
LawnSite Member
 
Join Date: Feb 2004
Location: Illinois
Posts: 32
Thanks, I hope to demo some later this week. The dealer I have bought all of my previous equipment from sells ferris and dixie chopper. Right now I am leaning toward a ferris, but I hear alot of good things toro, so I'll let you know. Thanks
__________________
K
Illinois
Reply With Quote
  #5  
Old 02-27-2004, 02:16 AM
Tonyr's Avatar
Tonyr Tonyr is offline
LawnSite Bronze Member
 
Join Date: Sep 2003
Location: Melbourne,Australia
Posts: 1,976
If ride quality is important while all are good-ish, comparing spring suspension machine to a suspension seat machine, the best ride I found from my comparison was the suspension seat gave a better ride, now if the ferris came with a suspension seat AND the springs, now that would be one awsome mower!

the springs while great and all, but just don't take as much rough out of the ride as a good suspension seat imo.

Ferris IS 3000 cuts well, overall a good rig, only drawback is if you mulch and require a dedicated bolt in mulch kit, they don't make one to my limited knowledge. Run meg-mo's on one and plug the shute, may solve that problem some?
__________________
Reply With Quote
  #6  
Old 02-27-2004, 02:21 AM
ALLFERRIS ALLFERRIS is offline
LawnSite Member
 
Join Date: Feb 2004
Location: Illinois
Posts: 32
Thanks, I'll keep this in mind when I decide to buy. I'll bring this up to my dealer also and see what he says
__________________
K
Illinois
Reply With Quote
  #7  
Old 02-27-2004, 08:47 AM
swim's Avatar
swim swim is offline
LawnSite Senior Member
 
Join Date: Feb 2004
Location: Franklin,TN
Posts: 357
A 60 in gets my vote.
Not to big for most residentual lawns and not near as bad about scalping as the larger mowers.
It will probably become your primary mower so why not get the most productive.
As far as which brand goes I would just make sure you have good dealer support.
Reply With Quote
  #8  
Old 02-27-2004, 01:19 PM
P&C Lawn Care P&C Lawn Care is offline
LawnSite Senior Member
 
Join Date: Sep 2003
Location: Yukon Oklahoma
Posts: 373
Ferris is super mower but last time I looked at them they did not have a good mulching kit, yazoo/keys will out mulch them. But the IS is good on them. Another thing to look at for a first ZTR is mid-mount or front mount. If you are use to running WB's with the deck out front you may want to look at a front mounted deck mower, but they will be higher in price than a mid-mount. Grasshopper makes the best front mount that I have seen. Front mounts may be a bit slower than a mid-mount but they give a better cut and you will have to do less trimming with them. I think a 52" or 60" deck is a good six deck, not too large or too small. But I guess you only asked what size.
__________________
David
P&C Lawn Care

"Impossible" is a word found only in the dictionary of fools. -Napoleon

Last edited by P&C Lawn Care; 02-27-2004 at 01:23 PM.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 11:08 AM.

Page generated in 0.08284 seconds with 7 queries