Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 03-27-2004, 08:26 PM
Wangel Wangel is offline
LawnSite Member
 
Join Date: Nov 2000
Location: Kansas
Posts: 54
Hard starting - Oil Starved

I have a 25 hp, Kohler Command engine. The engine developed an air pocket and was run about a minute or so without any oil. I fixed the problem and now the engine is hard to start. Meaning: Slow cranking. I put in a new battery and it helps a bit, but it required about 400 or 500 cca to start this thing. Once it starts, it runs fine. I have a few questions:

1) Will the engine smooth out a bit and wear in?

2) Will using synthitic oil help, or perhaps a lower weight oil?

I assume the tightness is in the pistons and rings? Anyway to free up the engine - Marvel Mystery Oil? Any Tips?
Reply With Quote
  #2  
Old 03-27-2004, 09:27 PM
ducky1 ducky1 is offline
LawnSite Senior Member
 
Join Date: Oct 2002
Location: s.e. Kansas
Posts: 252
How fast does the engine crank with the plugs out with no compression? Meybe be a bad ground or bad starter motor.
__________________
ducky
Reply With Quote
  #3  
Old 03-28-2004, 10:44 AM
xcopterdoc's Avatar
xcopterdoc xcopterdoc is offline
LawnSite Senior Member
 
Join Date: Nov 2003
Location: Parkton NC
Posts: 754
A minute or so with out oil or oil pressure is enough to do damage. Nothing ever wears "in", it always wears out! Pull the plugs and try to turn it over by hand. It should turn freely, if not, I'd take it apart and look at the connecting rod where it attaches to the crankshaft. Also check the cyclinder walls for scoring.
Reply With Quote
  #4  
Old 03-31-2004, 08:08 PM
Wangel Wangel is offline
LawnSite Member
 
Join Date: Nov 2000
Location: Kansas
Posts: 54
I removed the plugs and cranked the engine. It still cranked slow. I decided to try and cut the grass. After about 20 minutes the engine sputtered, loss power, and started spurting oil under the engine somewhere. I assume the engine is trashed now?
Reply With Quote
  #5  
Old 04-01-2004, 06:45 AM
SWD SWD is offline
LawnSite Senior Member
 
Join Date: Aug 2002
Location: Central Texas - West of Austin in the Hill Country
Posts: 990
That is a safe bet. The wear point that most affects small motors is the connecting rod bearing on the crank.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 10:26 AM.

Page generated in 0.07385 seconds with 7 queries