Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 05-06-2004, 10:05 PM
fixer67's Avatar
fixer67 fixer67 is offline
LawnSite Silver Member
 
Join Date: Apr 2004
Location: Tryon NC
Posts: 2,161
Walker PTO shaft tool

I got sick and tired of fighting for up to half and hour with PTO couplings so I came up with this tool. I made it out of 1/4 steel which turned out to be a mistake because I had to thin it down. 3/16 would be a better choice to use. I used an old coupling as a guide so there are no measurements, it is a cut and fit deal. You use the tool by simply pulling back the collar and inserting the tool in between the collar and clip. And with the collar locked back it is so much easier to slid the coupling on the shaft. I found it is easier to remove the tool by taking you trigger finger and pulling it stright down. If you look close you will see a "V" notch cut out in the tool this is for the ball to fit in.I hope these pictures load right.

<img src="http://img64.photobucket.com/albums/v196/fixer47/PTO Tool/807.jpg">

<img src="http://img64.photobucket.com/albums/v196/fixer47/PTO Tool/805.jpg">

<img src="http://img64.photobucket.com/albums/v196/fixer47/PTO Tool/806.jpg">

<img src="http://img64.photobucket.com/albums/v196/fixer47/PTO Tool/808.jpg">
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 11:25 PM.

Page generated in 0.06224 seconds with 9 queries