Register free!
Search
 
     

The Green Industry's Resource Center


Click for Weather
Reply
 
Thread Tools Display Modes
  #1  
Old 07-17-2004, 09:19 AM
smokymoose's Avatar
smokymoose smokymoose is offline
LawnSite Member
 
Join Date: Sep 2003
Location: Acworth Ga 30101
Posts: 16
transmission pulley

Can any one tell me the best way to remove a transmission pulley?...I am damaging the pulley by trying to pry it. Strait pulling doesn't move it ... The schematic parts diagram shows it pulling out with only the top nut holding it on. What trick am I missing.. If it makes a difference this is for a Country Clipper Jazee......Any help is appreciated...Thanks Josh
Reply With Quote
  #2  
Old 07-17-2004, 05:42 PM
jim dailey's Avatar
jim dailey jim dailey is offline
LawnSite Senior Member
 
Join Date: Jan 2001
Location: bellingham, ma. & daytona, fl.
Posts: 614
transmission pulley

Soak the heck out of it with penetrating fluid. Make sure that there isn't a set screw holding it on at the keyway. There usually is. Most times it is an allen screw. In a pinch, use a deep socket or piece of pipe, around the shaft but not touching it, and lightly hammer untuil the rust between the shaft and the pulley has broken. BUT, double-check for that set screw first. When re-assembling, use Never Seize on the shaft and pulley, so this won't happen again. When all else fails, a little bit of heat, a little bit, will usually set it free. BUT, remember, you have gas and oil in the surrounding areas. Be careful.
__________________
jim dailey
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 05:16 PM.

Page generated in 0.07751 seconds with 9 queries