Register free!

The Green Industry's Resource Center


Reply
 
Thread Tools   Display Modes
  #1  
Old 02-01-2005, 02:31 PM
SER SER is offline
LawnSite Member
 
Join Date: Mar 2004
Location: Naperville,Illinois
Posts: 60
Toro S-200 points replacement help

Hello All. I have a Toro S-200 2 cycle snow thrower. I am replacing the points and condenser. Does anyone know where I can look up a manual where they have step by step instructions on points replacement? I am somewhat familiar with the steps but am not 100% sure. Thanks all.
S.E.R.
Reply With Quote
  #2  
Old 02-02-2005, 10:32 AM
dutch1's Avatar
dutch1 dutch1 is online now
LawnSite Silver Member
 
Join Date: Dec 2004
Location: Jayhawk
Posts: 2,192
Remove upper and lower shroud halves, taking care to remove choke wire from choke lever, kill wire to switch. Pull out recoil rope and knot outside engine blower housing, Take out two bolts holding mounting to frame. Remove nut and washer holding mounting bracket to blower housing. Remove four bolts holding blower housing to block. Remove blower housing. Remove flywheel exposing points housing. Lift loop in spring over point housing to allow removal of points cover and gasket. Remove points. If points have not been replaced before you will have to cut the wire going to the points as another wire(kill) is also attached at the same point. Install new point set(30547A) and condensor(30548B). Leave points set loosely until arrow on crankshaft lines up with point opening. Set point opening to .020". Reverse disassembly procedure to get back together.

If the carb has had nothing done to it in a while, I would install a new diagphram and needle/seat while you have things broken down. Make a note on the order of the diagphram and gasket upon removal and replace in the same order. There are F and non F type carbs and the diagphram and gasket are reversed.

Good luck.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump





Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ©1998 - 2012, LawnSite.comô - Moose River Media
All times are GMT -4. The time now is 09:40 AM.

Page generated in 0.06037 seconds with 7 queries