'06 250 Powerstroke Trailer Light Plug Problem

Discussion in 'Trucks and Trailers' started by mowermankevin, Aug 2, 2009.

  1. mowermankevin

    mowermankevin LawnSite Senior Member
    Posts: 270

    Hey Y'all, have a problem with the trailer plug on the truck, the brake and turn signals work on the truck, the only thing on the trailer that works is the running lamps, I tested the plug coming out of the truck, and no signal, this is a very common problem and I have forgotten how to fix it. I pulled the fuses under the steering column, and ohmed those, even though I knew it was under the hood in the relay, big fuse box. I give up, but I'll damn sure write it down after this, I can't believe I've forgotten the cure, but sure 'nuff!!! appreciate any solutions, Thank You
     
  2. Tom'sLandscapeDesign

    Tom'sLandscapeDesign LawnSite Member
    Posts: 200

    Are the pins corroded? On my Tacoma I had to replace the 7-pin connector because all the pins were corroded..
     
  3. AI Inc

    AI Inc LawnSite Fanatic
    Posts: 25,164

    There is a fuse that runs em, check that first. I need to replace it quite ofton .
     
  4. mowermankevin

    mowermankevin LawnSite Senior Member
    Posts: 270

    Yes, I have tested and cleaned all terminals, the problem is in the fuse/relay box under the hood. There is no signal going to the plug from the wiring harness along the frame to the pigtail connector at rear of the truck. Appreciate the suggestions so far, I just forgot how I fixed it in the past, (gettin' too old to remember).
     
  5. Horsepower Lawns

    Horsepower Lawns LawnSite Member
    Posts: 213

    There should be a fuse for each turn/stop, its either under the hood or under the dash. Look in your owners book for the location & numbers.
    I think the fuse is a 7.5 amp.


    Fix the short & you won't be replacing it all the time.:waving:
     

Share This Page