2005 ASV RC100 w/ Loftness carbide cutting head.

Discussion in 'Marketplace' started by Stroker, Jun 8, 2008.

  1. Stroker

    Stroker LawnSite Member
    Posts: 92

    ASV RC-100 with a Loftness carbide head. The machine is a 2005 model with 390 hours. It has a new alternator and a new AC compressor. Tracks are in very good condition. The Loftness carbide head is a 2006 model. It has roughly 300 hours. Brand new high flow hydraulic hoses and custom push over bar. A 4 in 1 bucket for the machine is also included. Looking to pursue a new career opportunity. So need to sell.... $57,500

    PM or call (919)422-4372

    [​IMG]
     
  2. Itsgottobegreen

    Itsgottobegreen LawnSite Silver Member
    Posts: 2,177

    How much just for the mulcher.
     
  3. Stroker

    Stroker LawnSite Member
    Posts: 92

    Will do $13,500 for the mulcher
     
  4. Stroker

    Stroker LawnSite Member
    Posts: 92

    Would also like to add the cutting head had a new belt, new valve block, and new teeth installed roughly 20-30 hours ago.
     
  5. Stroker

    Stroker LawnSite Member
    Posts: 92

    I know somebody here is just itching to buy this and go destroy some plant life. ;)
     
  6. Stroker

    Stroker LawnSite Member
    Posts: 92

    Price reduced.... $55,000
     
  7. Stroker

    Stroker LawnSite Member
    Posts: 92

    Im tired of looking at it and paying insurance on it. Price Reduced AGAIN!!!! $53,500
     
  8. ashs inc

    ashs inc LawnSite Senior Member
    from alabama
    Posts: 595

    why are you selling. is there not a need for this type of business?
     
  9. Stroker

    Stroker LawnSite Member
    Posts: 92

    There is, especially if you advertise effectively. But we also run a small trucking company which I need to give my full time attention to.
     
  10. Stroker

    Stroker LawnSite Member
    Posts: 92

    This thing really needs to go. Make a reasonable offer and I will see what I can do.

    I hate to seperate the two units. But I will take $12,000 FIRM for the cutter alone. Brand new high pressure lines and valve block. Belt was also replaced less than 75 hours ago. Only 300 total hours on the cutter.
     

Share This Page