44" Toro Z-Master Stripes

Discussion in 'Lawn Mowing' started by NCSULandscaper, Jun 10, 2003.

  1. NCSULandscaper

    NCSULandscaper Banned
    Posts: 1,557

    Just finished building the stripe kit for my 44" Z Master.

    stripes_0144.jpg
     
  2. lawnranger44

    lawnranger44 LawnSite Senior Member
    Posts: 370

    looks awesome!!!!! great job!:)
     
  3. turfcare

    turfcare LawnSite Senior Member
    Posts: 276

    Looks good! I am thinking about putting one on my 62" Toro. How di you make yours?
     
  4. BobR

    BobR LawnSite Senior Member
    Posts: 714

    ¿¿¿ rubberband - roller or brush, which did you use ???

    BobR
     
  5. NCSULandscaper

    NCSULandscaper Banned
    Posts: 1,557

  6. gogetter

    gogetter Banned
    Posts: 3,256

    NCSU, looks great! So, how big of a difference is it from before the stripe kit? Slightly noticable? Very noticable?
     
  7. NCSULandscaper

    NCSULandscaper Banned
    Posts: 1,557


    The mower didnt stripe at all before i installed the kit. So i say it made an incredible difference.
     
  8. turfcare

    turfcare LawnSite Senior Member
    Posts: 276

    I appreciate the information, great job!
     
  9. dwost

    dwost LawnSite Bronze Member
    Posts: 1,666

    NCSU, looks great!!! What height did you end up mounting your roller at? take the measurement when its sitting on a hard surface, I'd like to compare it to mine. Also what height are you cutting at? TIA
     
  10. NCSULandscaper

    NCSULandscaper Banned
    Posts: 1,557

    Right now it is between 3/8 and 1/2" above the ground. The grass in the pic was cut at 3". However after playing around with the roller i am going to lower the roller so it is touching the ground for more enhanced stripes. And to add a better anti-scalp roller for the deck also and the weight of the deck alone will lay the grass down better from what i have seen.
     

Share This Page