A question for liquid micro/iron users

Discussion in 'Fertilizer Application' started by ArTurf, Sep 13, 2012.

  1. ArTurf

    ArTurf LawnSite Gold Member
    Male, from Ark
    Posts: 3,333

    I posted this on another thread but haven't gotten much of a response. Yesterday I tried a liquid micro/iron product for the 1st time and could not get it to disolve properly. It was a thick syrup and would not thin out. I even used very hot water. Is this common? Are there any tricks to make this easier?
     
  2. Landscape Poet

    Landscape Poet LawnSite Gold Member
    Posts: 3,637

    ArTurf....the micro package that I use is a liquid form. Is yours granular/powder concentrate? I am just applying to shrubs but from your other post your cost per k would work out to be in the same ball park. The product I use is called Complete. There is also a good liquid with micro package out there called Eagle 6 from plantfoodsystems that is in the same ball park. Hope that helps.

    Other than that...try hitting Greendoctor up on a PM. He has proved to be very knowledgeable on the subject and has been kind enough to respond to questions I have had.
     
  3. greendoctor

    greendoctor LawnSite Fanatic
    Posts: 8,821

    You might have a bottle that has gone off. Roots products are often formulated with seaweed extract. When that goes off, it either turns into globs of insoluble material or flakes at the bottom of the bottle.
     
  4. ArTurf

    ArTurf LawnSite Gold Member
    Male, from Ark
    Posts: 3,333

    I talked to the ROOTS rep, he figures it has gone bad. I will be returning it.
     

Share This Page