A solution for an Emark Hp

Discussion in 'Mechanic and Repair' started by nate121080, Apr 30, 2006.

  1. nate121080

    nate121080 LawnSite Member
    from va
    Posts: 66

    I have a 2005 hp 20hp kohler, 52". I was wanting to know how you disable the kill switch under the seat. I'm tired of having to get up and pick up sticks toys, bottles, ect and disengaging and engaging the clutch. I know I could go around and pick up all the stuff before hand its just a pain. Plus I dont have to mow on any hills its all flat so I'm pretty safe mowing. Any help? I want hold any party responsible for the information :)

    Thanks,

    Nathan
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    I'm not familiar with Exmark units but most have a switch built into the plug connector that plugs to the seat switch. First unplug the seat switch if that doesn't do it take a plastic wire tie wrap and wrap it around the plug connector between the two wires so it pushes in the small gray button between the two female spade connectors in the plug. If still nothing leave the wire tie in place and add a jumper wire to the two female connectors.
    I'm sure one of these combinations will do the trick.
     
  3. nate121080

    nate121080 LawnSite Member
    from va
    Posts: 66

    thanks fors the reponse. I unhooked the plug but it still cut off. I'll try the wire tie and jumper method in a minute and let you know if that works. Thanks again.

    Nathan
     

Share This Page